Sanyo FWSB426F - Experiencing the Surround Sound

–
13
–
EN
Experiencing the Surround Sound
1
Press on the Remote Control to activate the Surround sound.
• The LEDs blink in a spread manner, from the center (OPTICAL/COAXIAL) to both sides.
Surround status LED lighting patterns Sound effects
ON
AUX PAIR
LINE USB OPTICAL/
COAXIAL
U
S
B
OPTICAL
/
C
OAXIA
L
AU
X

AUX PAIR
LINE USB OPTICAL/
COAXIAL
LIN
E
U
S
B
O
C
AU
X
PAIR
L/
L
O
PTICA
L
CO
AXIA
L

AUX PAIR
LINE USB OPTICAL/
COAXIAL
LIN
E
US
B
O
C
A
U
X
PAIR
Outputs high realistic sounds.
2
If you want to set Surround sound to Off, press on the Remote Control once again.
• The 3 LEDs in the middle (USB, OPTICAL/COAXIAL, AUX) blink twice.
Surround status LED lighting patterns Sound effects
OFF
AUX PAIR
LINE USB OPTICAL/
COAXIAL
LIN
E
P
AI
R
US
B
O
C
AU
X
L/
L
O
PTI
CAL
CO
AX
IAL
Outputs the original sound.
NOTE(S)
• The Default setting is Off.
• This Setting will remain while the Soundbar is in Standby mode.