Sanyo FWSB426F - Adjust the Volume

–
12
–
EN
Adjust the Volume
1
To increase or decrease the Volume, press VOL +/- on the Remote Control.
Volume levels LED lighting patterns LED behavior
0 - 5
(6 levels)
AUX PAIR
LINE USB OPTICAL/
COAXIAL
LIN
E
US
B
O
C
Lights up for 3 seconds
(default: level 13)
6 - 11
(6 levels)
AUX PAIR
LINE USB OPTICAL/
COAXIAL
O
PTI
C
A
L
CO
AXIA
L
LIN
E
US
B
O
C
12 - 17
(6 levels)
AUX PAIR
LINE USB OPTICAL/
COAXIAL
LIN
E
AU
X
L/
L
O
PTI
C
A
L
C
OAXIA
L
US
B
O
C
18 - 23
(6 levels)
AUX PAIR
LINE USB OPTICAL/
COAXIAL
LIN
E
O
C
US
B
O
C
PAI
R
AU
X
L/
L
O
PTICA
L
CO
AXIA
L
24 - 29
(6 levels)
AUX PAIR
LINE USB OPTICAL/
COAXIAL
LIN
E
O
C
U
S
B
O
C
PAIR
L/
L
AU
X
O
PTICA
L
CO
AXIA
L
• When pressing VOL+/-, the Indicator(s) will show the current Volume. Pressing VOL+/- while the current Volume is
shown will increase/decrease the Volume.
• Pressing and holding VOL+ or VOL- will increase or decrease the Volume and the Indicator(s) will blink. When the Volume
has reached the maximum or minimum, the Indicator(s) will stop blinking.
2
To Mute the Sound, press on the Remote Control.
Volume levels LED lighting patterns LED behavior
Mute
AUX PAIR
LINE USB OPTICAL/
COAXIAL
LIN
E
P
AI
R
US
B
O
C
A
U
X
L/
L
O
PTI
CAL
C
OAX
IAL
The 3 LEDs in the middle
blink continuously.
• To Restore the Sound, press
again or press VOL +/-.
NOTE(S)
• The Volume might be influenced by MP3 or Bluethooth player. If the Volume is too low, adjust the Volume on the
Connected device.
• If the Volume level is Set Above 18 when the Soundbar is turned Off, the Volume will automatically be Reset to 18
when the Soundbar is turned back On.