Sanyo JA 300 Service Manual

SERVICE MANUAL
POWER AMPLIFIER
TA
300
(EUROPE)
SPECIFICATIONS
NOTE:
,
The
below
mentioned
specifications
are
mainly
based
on
the
[HF measurements
standard.
They
can
therefore
not
directly be compared with specifications based on the DIN standard or ther standards.
Continous output power ....... 25Wx 2 (at 8.ohms, Graphic equalizer controls ........ +10 dB (63/250/1000/
0.3% distortion) 4000/16000 Hz)
Total harmonic distortion ...... 0.1% (20 W output, High filter response ......,....... 7 kHz (—6 dB/oct.)
8 ohms) Loudness control response
Input sensitivity and impedance WORZTOKH? cacanecscesasd +8 dB/+4 dB
PHONO os cckaee ean ads 2.5 mV/47 kohms Signal to noise ratio ............ 90 dB |
AUX/TUNER/TAPE PLAY ... 150mV/47 kohms Power requirements ..:......... AC: 220V, 50Hz
Phono overload ifevel .......... 130 mV RMS (at 1kHz) Powerconsumption ............ 130 W
Output level AC output socket ............5. AC: 18 V, 300 mA
_TAPE.REC ...........;. 150mV Dimensions (Approx.) ........... 420 (W) x 220 (D) x
Frequency response ...... ~«e. 20—20000 Hz. 85 (H) mm
| (16-1/2” x 8-5/8" x3-3/8”’)
Weight (Approx.) .............. 4 kg (9 Ibs.)
* Specifications subject to change without notice.
WM-8507

Sanyo JA 300 Specifications

General

Damping factor	30
Power output	30W per channel (8Ω)
Frequency response	20Hz to 20kHz
Input sensitivity	2.5mV (MM)
Speaker load impedance	8Ω to 16Ω