To Next PageTo Next Page
Need help?Do you have a question about the Sanyo JA 224 and is the answer not in the manual?
Specifies the output power of 20W x 2 at 8 ohms with 0.9% distortion.
Details input sensitivity and impedance for PHONO (2.5mV/47 kohms) and AUX-CD/TUNER/TAPE PLAY (150 mV/47 kohms).
Indicates the overload level for the PHONO input is 130 mV RMS at 1 kHz.
Specifies the output level for TAPE REC as 150 mV.
Defines the frequency response for AUX-CD as 20-20,000 Hz.
Details the tone control response for BASS (±8 dB at 100 Hz) and TREBLE (±8 dB at 10 kHz).
Specifies loudness control response at 100 Hz ( +8 dB) and 10 kHz (+4 dB).
States the signal to noise ratio is 95 dB for AUX-CD.
Lists power requirements as AC: 220 V, 50 Hz.
Indicates a power consumption of 100 W.
Details the AC output socket as 18 V, 200 mA (max.).
Provides approximate dimensions: 420 (W) x 200 (D) x 80 (H) mm.
States the approximate weight is 4 kg (9 lbs.).
Details bias adjustment conditions for volume, balance, bass, treble, and switch settings.
Presents the IC block diagram for the LA6458D/6458S Dual Operational Amplifier.
Lists electrical components including capacitors, resistors, and other parts with their designations.
Details parts related to packing and accessories such as inner cases and manuals.
Lists components for the cabinet and chassis, including front panels, knobs, and brackets.
Provides a detailed list of components including resistors (R701-R731) and capacitors (C701-C721).
Lists parts for the Power Switch P.C.B. Assy, including resistors and switches.
Details parts for the Headphone Socket P.C.B. Assy, available in silver and black/brown variants.
Lists parts for the LED P.C.B. Assy, including LED components.
Presents the complete schematic diagram of the power amplifier circuit.
Illustrates the wiring connections for the main printed circuit board assembly.
Provides an exploded view of the SANYO JA 224 power amplifier for component identification.
General
