Standby: The set will be in “standby” mode after power-on;
MEM: The set will keep states before last power-off;
ForceOn: The set will turn on automatically; it also can be used as aging mode at factory;
s) Factory menu item: Shipment, all DTV/ATV programs for factory adjustment will be
cleared out first, then ATV channels will be preset according to customer requirements; the
item must be executed before shipment to clear out channels for factory adjustment;
t) Factory menu item: Other Setting->ISP Mode, the item will not be kept in memory, that
is, it will be always in “OFF” mode after turning on again;
“ON”: Upgrading unit software through VGA port while connecting to ISP apparatus;
“OFF”: Normal DDC functions of VGA port will recover;
Note: If there are date in EEPROM or upgrading software, please execute item “RESET ALL” to
clear out all data before adjustment for the first time.
4.2 ADC calibration
4.2.1 ADC calibration of VGA
1） Switch “source” to VGA channel;
2） Press key “SOURCE”, then press keys “2, 5, 8, 0” in turn to enter into initial factory menu;
3） Move cursor to item “ADC ADJUST” and press key “OK” to enter into inferior factory menu;
4） Input VGA signal（VG848: Timing 856（1024×768/60 Hz）, Pattern 914 Color Temp）; move
cursor to item “MODE ”，press keys “▲” and “▼” to select item “RGB”，then move cursor to
item “AUTO ADC” and press key “OK” to begin auto-adjustment until completing the
calibration.
4.2.2 ADC calibration of YPbPr
1） Switch “source” to YPbPr channel;
2） Press key “SOURCE”, then press keys “2, 5, 8, 0” in turn to enter into initial factory menu;
3）
Move cursor to item “ADC ADJUST” and press key “OK” to enter into inferior factory menu;
4） Input Y/Pb/Pr signal（VG848: Timing 976（1080i）,Pattern 918 SMPTE Color Bar）; move
cursor to item “MODE ”，press keys “▲” and “▼” to select item “YPbPr”，then move cursor to
item “AUTO ADC” and press key “ENTER” to begin auto-adjustment until completing the
calibration, prompt “SUCCESS” displaying below “AUTO ADC” means successful
auto-calibration.
4.3 White balance adjustment
Unless specified by customer, default color temperature “COOL” is 10000K and its chromatic
coordinates is (280、288); color temperature “NORMAL” is 8000K and its chromatic coordinates is
(295、305); color temperature “WARM” is 6500K and its chromatic coordinates is (323、329);
4.3.1 Adjustment procedure
The set should be working over 30 mins to be in stabler state before white balance adjustment;
Use white balance apparatus CA210 and switch to its BBY channel.
1） Switch “source” to HDMI channel;
2） Press key “SOURCE”, then press keys “2, 5, 8, 0” in turn to enter into initial factory menu;
3） Move cursor to item “W/B ADJUST” and press key “OK” to enter into inferior factory meny;
4） Input DVI/HDMI signal (16 Gray Scale Signal: 1024×768/60Hz
, TIMING: 856,
PATTERN:921); move cursor to item “MODE”, press keys “▲” and “▼” to select item
“HDMI1” or other HDMI channels, then move cursor to item “TEMPERATURE” and press
keys “▲” and “▼” to select item “COOL”;
To Next Page
Loading...
Need help?
General
