Sanyo LCD-32CA8Z - PC Adj

34
MENU OPERATION
PC Adj.
Press MENU button and the main menu will appear.
Press CHANNEL UP/ DOWN (Ÿź) buttons to select PC Adj.
1
Press VOLUME(+/-) buttons to enter into PC Adj. (Whenever
this menu is accessed initially, Auto Adjust will be the default
selection.)
2
3UHVV&+$11(/ 83'2:1ŸźEXWWRQV WR VHOHFWWKHLWHP
desired.
3
Press VOLUME(+/-) buttons to adjust value.
4
PC Adj. MENU
Auto Adjust
Select
Adjust
Return
Exit
MENU
Picture
Sound
Tuner
Time
Setup
PC Adj.
Ÿ
ź
ŻŹ
BACK
>>>
H-Position
V-Position
Clock
Phase
50
50
50
50
Select
Adjust
Return
Exit
MENU
Picture
Sound
Tuner
Time
Setup
PC Adj.
Ÿ
ź
ŻŹ
BACK
H-Position
V-Position
Clock
Phase
50
50
50
50
Auto Adjust
>>>
Auto Adjust
Press VOLUME(+/-) buttons , and the TV automatically detects
incoming signal, and adjust itself to optimize its performance. If the
image is not displayed properly, a manual adjustment is required
(Refer to following adjustments).
H-Position
The horizontal picture position will be moved to the left side by
pressing VOLUME(-) button. And it will be moved to the right side by
pressing VOLUME(+) button.(0~100)
V-Position
The vertical picture position will be moved to the down side by
pressing VOLUME(-) button. And it will be moved to the up side by
pressing VOLUME(+) button. (0~100)
Clock
Eliminate flicker from the image. Press VOLUME(+/-) buttons to adjust
Clock. (0~100)
Ŷ Press BACK button to return to the previous menu.
Ŷ Press MENU button or wait for 5~60 seconds (refer to "Duration" on
page 33) to exit menu operation.
Phase
Eliminate disorder from the image. Press VOLUME(+/-) buttons to
adjust Phase. (0~100)
Ɣ "PC Adj." doesn't work expect for PC mode.
Ɣ "PC Adj." doesn't work if no signal is input in PC mode.
Note:
Ɣ "Tuner" doesn't work in PC mode.
Ɣ "Colour" , "Tint" and "Sharpness" are not work in PC mode.
Inst. Manual - CA8Z.indd 34 6/27/2007 5:45:35 PM