i
REPLAC
NG THE PRINCIPAL PARTS OF THE CD CHANGER MECHANISM
b. REPLACING THE PLUNGER
&
. TUH7the
plL]nger “ON” and “OFF”, and confirm that the position of the control lever (407) and gear (408) change.
● To prevent improper movement of the lip of the control lever (407), confirm that it has no grease on it.
PLUNGER “OFF”
PLUNGER “ON”
CD MECHANISM
UP I DOWN CAM GEAR ( 391 )
=+--l
%
GEAR (408) N GEAR ( 408)
DOWN
UP
c. MOUNTING THE STOPPER AND ARRANGING THE
1’
~-------
LE
#--
‘;wn II- 1essthan02mm
UNGER(395)
GEAR
(408)
Cf) MECHANISM
TOR (414)
u
LEAD WIRES “
Arrange the lead wires so that they do not stick out
from the chassis.
This will prevent them from getting caught when the
disc tray opens and closes.
d
[
OPEN / CLOSE
SWITCH (339)
DISC SENSOR I?C.B
<
— “ LOWER “ ( 345)
-17-
To Next Page
Loading...
