SPECIFICATIONS
Name CO
2
incubator
Model MCO-18AC MCO-18AC(UV)
External dimensions W620 x D710 x H900 (mm)
Internal dimensions W490 x D523x H665 (mm)
Interior volume 170 L
Exterior Painted steel
Interior Stainless steel containing copper
Outer door Painted steel
Inner door Tempered glass
Tray 3 trays made of stainless steel containing copper
W450 x D450 x H12 (mm), Maximum load; 7 kg/tray
Access port Inner diameter; 30 mm, On the back side
Insulation Rigid polyurethane foamed-in place
Heating system DHA system (heater jacket + air jacket system)
Heater 282 W
Humidifying system Natural evaporation with humidifying pan
Temperature controller PID control system
Temperature display Digital display
CO
2
controller ON-OFF control system/TC sensor
CO
2
density display Digital display
Air circulation Fan assisted
Air filter
0.3μm, Efficiency; 99.97% or more
UV lamp
----- 4W X 1 (ozone-free emission)
Water level sensor
----- Optical type
-----
UV lamp failure alarm
Low humidifying water alarm
Alarm
Automatic set temperature alarm, Automatic set CO
2
density alarm
Upper limit temperature alarm, various gas/sensor/heater alarms
Remote alarm contact Allowable contact capacity: DC 30 V, 2 A
CO
2
inlet connection 4 to 6 mm diameter tube can be connected
CO
2
inlet pressure 0.03MPaG (0.3kgf/cm
2
G, 4.3psiG)
Accessories 3 trays, 3 sets of tray support, 1 gas tube, 1 humidifying pan,
Stacking plate A and B, 2 protective stickers, 2 tube bands
Weight 92 kg 93 kg
UV system kit (MCO-18UVS3) Standard equipment
Optional accessory
UV replacement kit (MCO-20UV), 4-20mA Interface(MCO-420MA, USA only)
Gas pressure regulator (MCO-100L)
Extra tray (MCO-47ST) including 2 tray supports, Half tray (MCO-25ST)
Automatic CO
2
cylinder changeover system (MCO-21GC), Roller base (MCO-18RB)
RS232C/RS485 Interface (MTR-480),
Ethernet (LAN) Interface (MTR-L03)
SANYO Data acquisition software (MTR-5000)
Note: Design or specifications will be subject to change without notice.
42
To Next Page
Loading...
