EasyManuals Logo

Sanyo MDF-U537D User Manual

Sanyo MDF-U537D
53 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
26
2.
2.2.
2.Temperature control and High, Low temperature alarm
<Temperature control>
Setting range -18℃~-40
Display range -50℃~+50
Setting method Press SET key and set the required value with key and
Key. Press SET key again to memorize the set value,
And then return to PV display.
Out of setting range : If change to out of setting range value by mistake and press
SET key , buzzer sound continuously for 1 second.
<Alarm>
High temperature alarm
When the internal temperature is higher than SV (
+5℃~+15), alarm lamp and
digital display is blinking. After 15min.later, buzzer will sound and remote alarm
contact will turn ON. (initial value: +10)
Low temperature alarm
When the internal temperature is lower than SV-5℃~-15℃), alarm lamp and digital
display is blinking. After 15min.later, buzzer will sound and remote alarm contact will
turn ON. (initial value: -10)
Setting method
Keep pressing key over 5 seconds to enter function mode (F00”).
Then press key to count up value. Change F01” to input high temperature alarm
value,F02” to input low temperature alarm value.
Set eitherF01” orF02” then press SET key to turn alarm temperature setting mode
to set required value with key and key.
Press SET key again to memorize value.
Out of setting range
If change to out of setting range value by mistake and press SET key, sound buzzer
continuously for 1second and remain in setting mode to maintain the setting value.
3.
3.3.
3.
Defrosting
This function is different by each model code (products) .
a. In PV display keep pressing DEF key over 5 seconds, defrosting will be started.
Model code 001 (MDF-U333) --- Force to turn compressor OFF.
Model code 002 (MDF-U537) --- Force to turn compressor & solenoid valve OFF. (Use 1 solenoid valve)
Model code 003 (MDF-U537D)
--- Single compartment Force to turn OFF solenoid valve at the ROOM lamp illuminated.
--- Both compartments Force to turn OFF 2 solenoid valves & compressor.
b. Press again DEF key to quit defrosting.Manual start and finish

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo MDF-U537D and is the answer not in the manual?

Sanyo MDF-U537D Specifications

General IconGeneral
BrandSanyo
ModelMDF-U537D
CategoryFreezer
LanguageEnglish

Related product manuals