- 5 -
Components on PCB
㻌
1. Mode of DIP switch (SW01)
a … Fan switch is used for fan motor
b … Capacity switch is used depend on cabinet capacity
㻌 c ... Adjust switch is used for shipping out only
2. How to initialize back-up memory
When you disconnect connecter(s) during power is given to PCB, and display and all switches are
locked by miss-feeding of micro-processor, follow the procedure (1) to (4) to initialize back-up memory.
(1) Turn back-up switch off.
(2) Turn power switch off.
(3) Turn power switch on.
(4) Turn back-up switch on.
Back-up switch Power relay
Buzzer
1
5
Triac
Heater
Power transformer
(For Zero calibration)
Key lock switch
Dip switch
a b c
MIR-162
abc
MIR-262
To Next Page
Loading...
