29
Basic Operation
black out ➜ the captured image ➜ normal ➜
• • • • •
Press the NO SHOW button on the remote control to black
out the image. To restore to normal, press the NO SHOW
button again or press any other button. When a projected
image is captured and set as “User” in the Logo selection
(see page 49), the screen changes each time you press the
NO SHOW button as follows.
“No show” disappears after 4 seconds.
NO SHOW button
Press the P-TIMER button on the remote control. The P-Timer
display “00:00” appears on the screen and the countdown
starts (00:00–59:59).
To stop the countdown, press the P-TIMER button. To cancel
the P-Timer function, press the P-TIMER button again.
P-TIMER button
P-Timer display
Press the IMAGE button on the remote control to select a
desired image mode of the screen. For more detail, see
pages 36, 43.
IMAGE button
IMAGE button
Remote Control
P-TIMER button
NO SHOW button
✔Note:
•See the previous page for the description of
other buttons.
To Next Page
Loading...
