-8-
ON
-
OF
F
POWER
AU
TO
SET UP
I
NPUT
WARNING
LAMP REPLACE
MENU
-
VOL
UME
+
VO
L
UME
SELECT
Follow these steps to replace the lamp.
For continued safety, replace with a lamp of the
same type. Do not drop a lamp or touch a glass
bulb! The glass can shatter and may cause injury.
Allow a projector to cool for at least 45 minutes
before you open the Lamp cover. The inside of the
projector can become very hot.
CAUTION
Turn off the projector and unplug the AC power cord. Let
the projector cool for at least 45 minutes.
Loosen 2 screws and pull out the lamp assembly by
grasping the handle.
1
3
Replace the lamp with a new one and secure the two (2)
screws. Make sure that the lamp is set properly. Close
the lamp cover and tighten the screw.
4
Remove 1 screw with a screwdriver and remove the
lamp cover.
2
Connect the AC power cord to the projector and turn on
the projector.
6
Reset the lamp counter.
See “Resetting the Lamp Counter” on the next page.
5
CAUTION
Top Control
LAMP REPLACE
indicator
Maintenance
Lamp
Lamp Cover
Screw
Screw
Handle
Screw
ORDER REPLACEMENT LAMP
Type No. Service Parts No.
POA-LMP106 610 332 3855
When the projection lamp of the projector reaches its end of life,
the Lamp replacement icon appears on the screen and LAMP
REPLACE indicator lights yellow. Replace the lamp with a new
one promptly. The timing when the LAMP REPLACE indicator
should light is depending on the lamp mode.
Lamp Replacement
WARNING:
TURN OFF THE UV LAMP BEFORE OPEN-
ING THE LAMP COVER
Lamp replacement icon
✔Note:
• The Lamp replacement icon will not appear when
the Display function is set to “Off”, during “Freeze”,
or “No show”.
To Next Page
Loading...
