1
1 - 7
1) When two remote control units are being used in one group control*
system,
a) the most recent button that is pressed on any remote control unit
is effective.
b) either a main-remote control unit or a sub-remote control can set
the timer.
*Group control means that maximum up to 8 indoor units can be
concurrently controlled with a remote control unit.
2) If a power failure occurs in timer mode, the time counted up to that
point will be stored in memory.
After power is restored, the timer starts again counting up to the set
time.
NOTE
Remote Control Unit (continued)
NOTE
06-212 PAC-i_IM_Sec1 4/12/06 7:15 PM Page 7
To Next Page
Loading...
Need help?
General
