EG-13
EG
1. Press and hold for 2 seconds to display the upper limit temperature
setting screen.
, and the upper limit temperature start flashing.
(The default value of the upper limit temperature is 38 °C.)
2. Press / to select the upper limit temperature and press to
fix the value. The lower limit temperature setting screen is displayed.
3. Press
/ to select the lower limit temperature, and press to
fix the value. The outing function setting is completed. (The default value of
the lower limit temperature is 10 °C.)
• Canceling the outing function
Press and hold for 2 seconds while the outing function is set.
• Outing function indication
Outing function
indication
Off
Flashing
Lighting
Status
The outing function is not set.
The outing function is now being set, or under operation.
Although the outing function is set, not under operation.
• Setting the Outing Function
2
3
Note
A remote controller loses outing function operation information when it is cut for more than one hour
during the outing function operation by electricity. It reverts from the blackout, and an air conditioner
does not drive in outing function when operation is started. At this time, an air conditioner does not stop
at outing function.
To Next Page
Loading...
