Sanyo RCS-TM80BG - Setting the Present Time; Enter Present Day and Time Setting Mode; Set Todays Day of the Week; Set the Present Hour

EG-5
EG
1. Press and hold for more than 2 seconds to enter in
the present day and time setting mode.
Once you enter in the setting mode,
, “ ”(day) and
“time” flash.
2. Set “
” to today’s day of the week.
Press
*
1
to move “ ” (flashing on the
display) in the order of : Su → Mo → Tu → .... Press
to move it in the order of : Su → St → Fr → ....
*
2
While in time setting mode, the temperature setting
buttons function as
(changing day) button.
3. Press
to change the present “hour” in the range of 0 to 23*
2
.
Set the present hour and press
.
The “hour” digits light up, and the “minute” digits start flashing.
*
2
If the clock uses the 12 hours AM/PM setting, the hour is displayed in the range of AM 0 to 11/PM 0
to 11.
4. Press
, to change the present “minute” in the range of 0 to 59.
Set the present minute and press
. The day and time are set and finishes the
setting mode.
Note
* The unit returns to the normal mode if the is pressed or there is no operation made in 3 minutes
during the setting. In this case, all the settings in progress will be lost.
* If the present time is invalid, “- - : - -” is displayed.
If the power failure for more than 1 hour occurs, check if the set data of day and time are valid.
3. Setting the Present Time
1,3,43,4 2