Sanyo RCS-TM80BG - 4. Set the Program Pattern

EG-8
4. Set the program pattern.
(program step 3)
There are 4 program patterns.
Pressing
/ repeats
the following display patterns.
Pattern 1
The indoor unit starts operation at the
programmed time.
Pattern 2
The indoor unit stops operation at the
programmed time.
Pattern 3
The indoor unit starts operation at the
programmed time and changes the
temperature settings.
Press
/ to change the
temperature setting.
Pattern 4
The indoor unit changes the temperature
setting at the programmed time.
Press
/ to change the
temperature setting.
Select the program pattern and press . The program timer setting is confirmed and the unit enters the
confirmation mode
.
Note
• If you press during the setting, it returns to the program confirmation mode.
• If there is no operation made for 3 minutes during the setting, it returns to the normal mode.
In this case, all the settings in progress will be invalid.
4. Weekly Program Function (Continued)
Pattern 1
Pattern 2
Pattern 3
Pattern 4