Sanyo RCS-TM80BG - Changing the Program Timer; 1. Select Program to Change; 2. Set the Hour; 3. Set the Minute

EG-7
EG
• Changing the Program Timer
To change the program setting, follow the steps below.
1. Select the program you want to change in the
program confirmation mode, and press
. The
enters the setting mode of the program currently
displayed.
* In the program setting mode,
, “hour”,
“minute” and “item” flash on the display.
2. Set the “hour”. (program step 1)
Press
/ to set the “hour”.
Confirm the “hour” and press
. The enters the program changing
mode
(setting of the “minute”).
3. Set the “minute”. (program step 2)
Press
/ to set the “minute”.
Confirm the “minute” and press
.The unit enters (the program
pattern selection mode).
1,2,3,4 4
2,3,4
Program step1
Program step2
SET
SET
SET
SET
CANCEL,DEL
normal remote controller
program check
PROGRAM CANCEL
CANCEL,DEL
CANCEL
PROGRAM
SET,CANCEL,DEL
SET,CANCEL
Program
Changing hour digits
Changing minute digits
Changing patterns
Selecting copy source
Selecting copy destination