To Next PageTo Next Page
Need help?Do you have a question about the Sanyo SAP – K92AH and is the answer not in the manual?
General| Refrigerant | R410A |
|---|---|
| Cooling Capacity | 9000 BTU/h |
| Power Supply | 220V, 50Hz |
| EER (Energy Efficiency Ratio) | 3.0 |
| Outdoor Unit Dimensions (W x H x D) | 780 x 540 x 285 mm |
| Outdoor Unit Weight | 28 kg |
Details performance, electrical ratings, features, and dimensions for indoor and outdoor units.
Lists specifications for key internal components of indoor and outdoor units.
Provides technical data for miscellaneous components like transformers and thermistors.
Explains the importance and method for insulating refrigerant tubing to prevent condensation.
Graphical representation of operating current and pressure at various temperature conditions.
Illustrates air throw distances based on flap angle and air velocity.
Tables detailing total and sensible cooling capacity under different conditions.
Chart showing heating capacity ratio relative to outdoor temperature.
Lists running amps and power input for units during cooling and heating.
Provides detailed wiring schematics for indoor and outdoor unit connections.
Guidelines for choosing optimal locations for units, avoiding hazards.
Recommendations for installing the remote control unit to ensure proper operation.
Specifies recommended wire sizes and lengths for power supply connections.
Explains how the system regulates room temperature by cycling the compressor.
Describes the dehumidification mode and its operational cycles.
Details the AUTO mode function that switches between cooling and heating.
Function to prevent the indoor heat exchanger coil from freezing.
Protection mechanism to prevent compressor damage from excessive current.
Prevents overheating of the indoor heat exchange coil or compressor.
Controls indoor fan speed to prevent cold air drafts during heating.
Outlines the sequence and conditions for defrosting operation.
Automatic adjustment of outdoor fan speed based on ambient temperature.
Initial checks for power supply wiring, inter-unit wiring, and connections.
Troubleshooting steps for when the unit fails to start or operates intermittently.
Diagnosing issues with specific components like fans or compressor.
Addressing problems like incorrect mode switching or poor performance.
Procedures for identifying and resolving issues caused by defective thermistors.
How to measure insulation resistance of power supply wires and unit components.
Steps for checking the continuity of fuses on the printed circuit board assembly.
Method for testing motor capacitors using a multimeter.
Instructions for assigning unique addresses to multiple indoor units for remote control.
