PROPER CARE AND CLEANING OF THE
BREAD FACTORY PLUS
* (_lnplug the power cord and allow
Caution: Do not pour water into the
the breadmaker to cool completely.
inner case or submerge the breadmaker in water.
* Use only a mild detergent to clean the breadmaker. To avoid damaging the smooth
surfaces of the breadmaker and inner pot, do not use chemical kwid cleaners (such
as benzene or thinners), nonabrasive or abrasive cleansers, or scrubbing brushes or
pads to clean the breadmaker or inner pot surfaces.
Tha Outar Body, Lid and Innar Caae
. Wipe the outside and the lid with a damp cloth.
● Remove any flour, bread crumbs or other materials from
case using a damp sponge or cloth or a small, portable
Tha Inner Pot and Kneader Blade
the inside of the
vacuum cleaner.
inner
● Both the inner Dot and the kneader blade are coated with a nonstick surface. DO
not use any cleaners or utensils thet could scratch this surface.
● The nonstick surface may change in appearance after continued use. This is caused
by moisture and steam and has no effect on its use or quality.
● Remove the inner pot with kneader blade from the inner case and wash with a
damp sponge or dish cloth, making sure the kneader blade mounting shaft is also
vew clean. The inner pot interior can be washed with soapy water, but do not
submerge inner pot in water. Wash after each use and dry thoroughly.
● DO not soak either part in water or wash in a dishwasher.
● If it is difficult to remove the kneader blade from the inner pot, fill the inner pot
with warm water and let it stand a few minutes to allow any baked-on
dough to soften.
● If the hole in the kneader blade becomes clogged, clean it out with a soft
brush or wooden or plastic toothpicks.
Before storing the Breadmaker
bread
bristle
● Make sure the breadmaker has cooled completely and all parts have been
thoroughly cleaned and dried.
● Leave the lid open until the breadmaker is completely cool. This will avoid the
formation of any moisture in the inner case.
–16–
To Next Page
Loading...
