5
NOTES OF USE
(1) Conduit holes (sealed):
Connect the wires through the hole. The conduit holes are on
the side of the unit casing. The access hole is sealed at the fac
tory. Pierce the hole as needed and connect the line.
(2) Unit Casing:
The unit casing is made of Acrylonitrile Butadiene Styrene(ABS)
30% + Polycarbonate (PC)70%.
(3) Dome Casing:
The dome cover is made of polycarbonate.
(4) Zoom lever:
Loosen lock screw anti-clockwise and adjust the camera’s focal
range as desired. Tighten lock screw clockwise after adjustment.
(5) Focus lever:
Loosen lock screw anti-clockwise and adjust focus for best pic-
ture sharpness. Tighten lock screw clockwise after adjustment.
Fig-1
(a) Video out connector (b) Power connector (DC12V/AC24V)
■ LOCATION AND FUNCTION OF PARTS
■ CONNECTION
To Next Page
Loading...
