Sanyo VCC-MC800P - Using the Black and White Mode Only (B;W)

Camera Settings (CAMERA)
21
b Using the black and white mode only
(B/W)
Regardless of the luminance level, only use the black and white
mode to view the image.
1
Use the joystick lever (xy) to select [DAY/NIGHT],
use the lever (vw) to select “B/W y”, and press the
[ENTER] button.
The D/N SETTING-B/W screen appears.
2
Use the joystick lever (xy) to select [BURST] and
use the lever (vw) to select “ON/OFF”.
Sets whether the color burst signal is turned on or off. In
general, set this option to “OFF”.
Available settings:
•ON: The color burst signal is turned on.
•OFF: The color burst signal is turned off.
3
Use the joystick lever (xy) to select [FOCUS] and
use the lever (vw) to select focus compensation
mode.
In general, set this option to “1”. If images are out of focus, set
this option to “2”.
Available settings:
•1: Near-infrared wavelength correction (around 900nm) is
set during the black and white mode.
•2: Visible light spectrum is set during the color mode.
☞ After completing setting, use the lever to move the cursor to
[MENU] and select “BACK” or “END”.
D/N SETTING-B/W
BURST
FOCUS
PRESET
MENU
OFF
1
OFF
BACK
L5BW2_XE(VCC-MC800P_MC700P)(GB).book 21 ページ ２００７年１月１８日 木曜日 午前１０時１８分