5
Checking the menus and zoom position using simple
monitor output
1
Fully loosen the four cover fixing screws
(A), and then pull the cover forward to
remove it.
2
Use an alligator clip cable to connect the
MONITOR pin on the circuit board at the
bottom of the camera to the ground.
A dedicated MONITOR connector (D) is
provided for portable monitors.
1Checking and changing the menu
settings
2Checking and changing the zoom
position
• The optional camera control unit
(VAC-70) can be used to perform same
operations as the camera.
& See page 15.
3
Install the camera cover, and then
tighten the four cover fixing screws (A)
evenly.
• If only removing the camera cover (B),
partially loosen the cover fixing screws
(A).
• If removing the lens cover (C) too, fully
loosen the cover fixing screws (A).
The screw washers on the inside will
come loose. Be careful not to lose
them.
MONITOR
GND
D
In order to maintain waterproof
performance, tighten the cover fixing
screws to the following torques.
A: 0.5 - 7 N·m (5 - 10 kgf·m)
(A)
B
C
A
L5CE2_CD2_XE(INSTALLATION).book 5 ページ ２００８年４月１６日 水曜日 午後３時１８分
To Next Page
Loading...
