Sanyo VHR-1110 Series - Page 17

2-4-5. CAPSTAN MOTOR (See Fig. 2-4-4.)
(1) Disconnect the capstan motor connector.
(Note)
Be sure that the power is off [the power switch in the
OFF position} when connecting or disconnecting the
connector.
(2) Remove the screws (a), and then remove the bracket.
(3) Remove the screws (b) securing the capstan motor, and
then remove the motor.
(4) Install the new capstan motor by using the reverse
order of the removal procedure.
Capstan motor
Bracket
Fig. 2-4-4
2-4-6. ROLLER ASSEMBLY (See Fig. 2-4-5)
(1) Remove the washer (a), and than remove the roller
assembly.
(2) Install the new roller assembly by using the reverse
order of the removal procedure.
Washer (a)
Roller Assy.
—16—