Sanyo VHR-1110 Series - Page 18

2-4-7.
UPPER
DRUM
(See
Fig.
2-4-6.)
2-4-8.
DRUM
MOTOR
(See
Fig.
2-4-7.)
(Models VHR-2100EX, VHR-2300 EX, G) (Models VHR-2100 EX, VHR-2300 EX, G)
(1)
Remove
the
screw
(a),
then
remove
the
brush.
(1)
Remove
the
screws
(a)
securing
the
rotor,
and
then
(2)
Remove
the
screws (b)
which
hold
the
upper
drum, remove
the
rotor.
and than remove the soldered lead wire. (2) Remove the screws (b) securing the stator, and then
(Note) remove the stator.
Be careful to the solder the lead wire at correct position. (3) Install the new drum motor by using the reverse order
(3)
Check
the
tape
path.
of
the
removal
procedure.
VIDEO HEAD LEAD WIRE POSITION (TOP VIEW)
RED TUBE (don’t remove)
Yellow lead wire Red lead wire
Brown lead wire Yellow lead wire
BROWN TUBE
Fig. 2-4-6
(Note)
Use the torque gauge screwdriver (VHJ-0014) for installa-
tion of the stator and rotor.
The tightening torque of the stator is 3kg-cm, and for the
rotor is 2kg-cm. (When installing, first tighten to a tem-
porary tighteness and then tighten to the specified torque.)
=