Sanyo VHR-1110 Series - Page 19

2-4-9. DRUM ASSY. (See Fig. 2-4-8.)
(Models VHR-2100 EX, VHR-2300EX, G)
(1) Remove the screw (a), and then remove the brush. (4) Remove the screws (c), and then remove the drum
(2) Remove the screws (b), and then remove the shield assembly.
plate. (Be careful not contact the video heads)
(3) Remove the soldered lead wire of MC-30. (5) Install the new drum assembly by using the reverse
order of the removal procedures.
(b)
Shield plate
Drum Assy. |
Q
ee drum rotaly trans, lead a
install position
P.C.B. MC-30
(Black marking)
(Black
marking)
eA
a
Green
wire
Red wire
From under drum Trans.
—18—