Sanyo VHR-1110 Series - Page 30

2-6-6. MODE DETECTION SWITCH POSITIONING
(See Fig. 2-6-6.)
Mode switch positioning is necessary when the mode detec-
tion switch is removed and replaced.
(1) Turn the pulley completely clockwise, and then return
it one turn counterclockwise.
(2) Check to be sure that the triangle mark on the mode
detection switch and the triangle mark on the slide are
aligned.
(3) If they are not aligned, loosen the two screws (a), move
so that the triangle mark of the mode detection switch is
aligned, and then tighten the screws (a).
(Bottom View)
AN Triangle mark
—29—