EN-30
CAPTURE MODE
Burst
This mode is used for continuous shooting. 3 pictures are taken continuously once the
shutter release button is pressed. Secure the camera to a tripod or place it on a stable
surface.
1. Rotate the mode dial to , , , ,
, or .
2. Press the power switch to turn on the
power.
3. Press the four-way controller (S/) and
use (S) to select [Burst]. You can also
change the setting using four-way
controller (WX).
4. Press the button to confirm the setting.
The indicator is displayed on the monitor screen.
5. Press the shutter release button halfway to lock the focus.
6. Press the shutter release button to capture a sequence of images.
• In Burst mode, the flash mode will be set to Flash Off automatically.
ptu
e Mod
Bu
OK :
OK :
Capture Mode
Burst
To Next Page
Loading...
