18
Below-Balance Weighing
A port for a below-balance weighing hanger
is located on the bottom of the balance (for models
with a weighing capacity of 12 kg or more, see
chapter on “Accessories.”
$ Below-balance weighing is not permitted in
legal metrology.
G Open cover plate on the bottom of the balance.
G Using the built-in hanger 1: Attach the sample
(e.g., using a suspension wire) to the hanger.
$ If necessary, install a shield for protection against
drafts.
G Remove the brass screw
G Suspend the below-balance weighing hook
supplied from the hanger
G If necessary, install a shield for protection against
drafts
To Next Page
Loading...
