127
Configuring a Printout
● Turn on the balance: press e
● Select Printout: press the q soft key 3 x, then the O soft key once
Printout Application-defined Stability Without stability
1
)
output parameter
ο After stability
Print on request,
ο Off
then tare On
Auto print Off
upon
ο All values
intialization Only main values
Printout See section on
configuration “Printout Configuration”
Automatic output Stability
ο Without stability
of displayed value parameter With stability
Automatic after weight change
2
)
Start/stop Use print key
ο Not possible
Time interval
ο 1 display update
2 display updates
10 display updates*
100 display updates*
Output to Serial printer Off
interface ports Serial
ο Application-defined output
communication Automatic output of displayed value
(PERIPHERALS)
Serial Off
printer
ο Application-defined output
(PRINTER)
Line format For raw data (16 characters)
ο For other apps/GLP (22 characters)
ISO/GLP/GMP
ο Off
printout Only for calibration/adjustment
Always on
Identification # Lot ID (L ID):
ID1:
ID2:
ID3:
ID4:
Factory settings: No
only printout Yes
ο = factory setting
* = not applicable to verified balances
1
) = Information on use in legal metrology: Only permitted for control purposes; printouts are not allowed
2
) = auto print when load change is > 10d and stability is reached; no printout until residual difference in load value is < 5d
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...