Need help?Do you have a question about the Sartorius Gem GE7101 and is the answer not in the manual?
General| Capacity | 7100 g |
|---|---|
| Readability | 0.1 g |
| Calibration | External |
| Display | LCD |
| Repeatability (Std. Dev.) | 0.1 g |
| Linearity | ±0.2 g |
| Power Supply | AC adapter |
| Weighing Units | g, kg, oz, lb, ozt, dwt, ct, mom, tl |
| Interface | RS-232 |
Service course requirement and prohibition of unauthorized repair work.
Overview of key service checks: repeatability, off-center error, sensitivity, and linearity.
Requirements for ordering and replacing main PCBs, including model and serial number.
Methods for adjusting off-center load on specific TE models using filing or adjustment screws.
Method for performing span adjustment using external calibrated weights.
Steps to activate BPI mode by connecting the BPI adapter and performing sequence.
Overview of essential checks and adjustments including overload stop, zero point, repeatability, off-center error, span, and linearity.
Procedure for checking overload stops after strain-gauge system replacement.
Detailed steps for checking the overload stop using test weights and software.
Explanation of zero-point offset adjustment necessity and procedure.
Steps for adjusting zero-point offset using a digital voltmeter and specific components.
Procedure for checking repeatability using test weights and calculating standard deviation.
Method for adjusting off-center error by filing thin parts on the load receptor.
Methods for adjusting span using service software or calibration weights.
Procedure for checking and adjusting linearity using service software.
Procedure for adjusting off-center loading error on double-lever systems using adjustment screws.
Steps for adjusting off-center error by filing thin places on the upper guide.
Methods for adjusting span using service software or calibration weights for models like TE124S.
Procedure for checking and adjusting linearity using service software.
Procedure for replacing the main PCB, including data backup and post-replacement adjustments.
To Next Page