View and Print Display Pages
You can use the manual mode to
print display pages (for lots, samples,
values and results).
To view and print a display page
for values:
● Show the display page for lots: press the
Lot soft key
● Show the display page for samples:
press the
Sample soft key
● Show the display page for values: press
the
Values soft key
● Print the display page for values:
press p/r
$ Select amount of data to be included on
the printout: press the
q or Q soft key
● Confirm print command:
press the
l soft key
The display pages for lots and samples
can be printed when they are shown on
the balance display.
View the Display Page for Results:
● Show the display page for lots: press
the
Lot soft key
● Show the display page for samples:
press the
Sample soft key
● Show the display page for values:
press the
Values soft key
● Show the display page for results:
press the
Result soft key
● Print the display page for results:
see instructions for printing the display
page for values
You can manually print the display page
for statistics when it is shown on the
balance
To view the display page for statistics:
● Select statistics: press the
Stat.
soft key
$ For samples each with a different
number of backweights:
Select the kind of statistics:
press the
q or Q soft key
$ Confirm selection: press the
l soft key
Deleting or Omitting a Lot or Sample
Lots can be deleted; samples can be
deleted or omitted.
You can choose between
– deleting the current lot and
– deleting all lots.
You can choose whether
– the active sample is deleted entirely, or
– only the values from the active sample
are deleted, or
– all samples are deleted completely, or
– only the values from all samples are
deleted, or
– a sample is omitted
Deleting a Lot/Sample
● Activate the display page for
lots/samples
● Select the desired lot/sample
● Select the “Delete” function:
Press the
Delete key
● Define the lot(s)/sample(s) to be deleted
and confirm
● Select “Yes” to complete the delete
function or “No” to cancel it
Example: Deleting all samples
completely (in this case, 3 samples)
Omit or Include Sample
● Activate the display page for samples
● Select the desired (or omitted) sample
● Delete: Press the
Delete key
● Omit: Press the
Omit key
Example: Sample 3 has been omitted
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during alphanumeric
input), and
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
● Press the
Cal soft key
> See the section entitled “Calibration/
Adjustment” for further instructions
Setup (Parameter Settings)
● Press the s key
> See the chapter entitled “Configuring
the Balance” for further instructions
Turning Off the Balance
● Press the e key
> The balance shuts off
> The display goes blank, then OFF or
Standby is displayed with backlighting
82
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...