Need help?Do you have a question about the Sartorius Master Pro LA2200S and is the answer not in the manual?
Description of the functions of each key on the balance.
Steps to turn on the balance and access the SETUP program.
Procedure for entering data into the balance.
Flowchart illustrating user and service SETUP program navigation.
Steps to activate BPI mode for calibration or PCB replacement.
How to enable expanded calibration/adjustment functions.
List of available adjustment options within service mode.
Methods for performing external linearization.
Steps to manually input specific linearization weights.
Detailed procedure for the external linearization routine.
Procedure for internal span adjustment using the built-in weight.
Overview of external span adjustment methods.
Inputting specific weights for span adjustment.
Performing span adjustment using pre-defined stored weights.
Procedure to overwrite the internal calibration weight.
Steps to define and use custom calibration weights.
Test for reproducibility of the built-in calibration weight.
Steps to disconnect and remove the display/control unit.
Procedure for opening specific types of weighing cells.
Procedure for opening large single-casting block weighing cells.
Steps to access and locate the main PCB.
Detailed steps for opening the display and control unit.
Procedure for replacing the balance's built-in calibration weight.
Factors to check and adjust during calibration.
Detailed steps for adjusting the preload.
Steps to adjust the off-center load for different systems.
How to check the span accuracy of the balance.
Overview of linearity checking procedures.
Linearity check for balances with lower resolution.
Linearity check for high-resolution and PolyRange balances.
Steps to replace the PCB in the display and control unit.
Procedure for replacing display unit components.
Steps to replace the main balance PCB.
PCB replacement procedures for specific balance systems.
PCB replacement for large single-casting block systems.
To Next Page
General