Need help?Do you have a question about the Sartorius Master Pro LA4200S and is the answer not in the manual?
General| Maximum Capacity | 4200 g |
|---|---|
| Readability | 0.01 g |
| Calibration | External |
| Display | LCD |
| Linearity | ± 0.02 g |
| Power Supply | AC Adapter |
| Interface | RS-232 |
| Operating Temperature | 10°C to 30°C |
| Repeatability | ±0.01 g |
Diagram illustrating user and service access paths within the SETUP program.
Location and function of access switch; activating BPI mode.
Lists available adjustment options within the service mode.
Programming balance with custom weights for linearization.
Executing external linearization using user-defined weights.
Steps for internal span adjustment using the built-in calibration weight.
Performing internal span adjustment with built-in calibration weight.
Inputting calibration weights for span adjustment.
Procedure to enable expanded calibration and adjustment functions.
Overview of adjustment options available in service mode.
Span adjustment using pre-defined weights.
How to overwrite internal calibration weight after service.
Calibrating balance using user-defined weights.
Step-by-step guide to remove the display and control unit.
Procedure to open weighing cell for small/brass systems.
Procedure to open weighing cell for large single-casting systems.
Steps to access the main printed circuit board.
Instructions for opening the display and control unit.
Procedure for replacing the internal calibration weight.
Methods for checking the preload value.
Procedure to replace the PCB in the display and control unit.
Steps to replace display unit, backlighting, and keypad overlay.
Procedure for replacing the balance PCB.
Replacing PCB in small/brass systems.
Replacing PCB in large single-casting block systems.
To Next Page