Sartorius ME36S - Pin Assignment Charts

145
Pin Assignment Chart, 25-contact Female Connector, RS-232:
Pin 1: Signal Ground
Pin 2: Data Output (TxD)
Pin 3: Data Input (RxD)
Pin 4: Signal Ground
Pin 5: Clear to Send (CTS)
Pin 6: Internally Connected
Pin 7: Internal Ground (GND)
Pin 8: Internal Ground (GND)
Pin 9: Reset _ In
Pin 10: – 12 V Output
Pin 11: + 12 V Output
Pin 12: Reset _ Out
2
)
Pin 13: + 5 V Output
Pin 14: Internal Ground (GND)
Pin 15:
Pin 16:
Pin 17:
Pin 18:
Pin 19:
Pin 20: Data Terminal Ready (DTR)
Pin 21: Supply Voltage Ground (GND)
Pin 22: Not Connected
Pin 23: Not Connected
Pin 24: Supply Voltage Input + 15 ... 25 V
Pin 25: +5 V Output
*) = See “Additional Functions” for information on changing pin assignments
1
) = Hardware restart
2
) = Restart peripherial device
Pin Assignment Chart, 9-contact Female Connector, RS-232 (Optional):
Pin 1: Not Connected
Pin 2: Data Output (TxD)
Pin 3: Data Input (RxD)
Pin 4: Clear to Send (CTS)
Pin 5: Signal GND
Pin 6: Not Connected
Pin 7: Not Connected
Pin 8: Data Terminal Ready (DTR)
Pin 9: Not Connected
Pin Assignment Chart, 12-contact Round Female Connector,
RS-485 (Optional):
Pin A: F2 Function Key / Control Output 3 “Heavier”
Pin B: RS-485: RxD – TxD – N; RS-232: TxD
Pin C: RS-485: RxD – TxD – P; RS-232: RxD
Pin D: RS-485: Not Connected; RS-232: DTR
Pin E: Signal GND
Pin F: + 5 V
Pin G: Left Draft Shield Key / Control Output 1 “Lighter”
Pin H: RS-485: Not Connected; RS-232: CTS
Pin J: Cal Function Key / Control Output 2 “Equal”
Pin K: r Key / Universal Switch
Pin L: w Key / Control Output 4 “Set”
Pin M: +12 V Output
Connecting a Bar Code Scanner or an Extra Keyboard
You can connect a bar code scanner or an extra keyboard using the following
female connectors:
– 25-contact D-Submini female connector (using an adapter)
– 12-contact round female connector (using an adapter)
– 5-contact direct DIN female connector
1
14
13
25
Pin Assignment Charts
rtkey/ F1 function F2 function c key/
key/ Control key/ key/ Control
Universal output 1*) Control Control output 4*)
switch*) “lighter” output 2*) output 3*) “set”
“equal” “heavier”
Female Interface Connector:
25-position D-Submini, DB25S, with screw
lock hardware for cable gland
Male Connector Used (please use
connectors with the same specifications):
25-pin D-Submini, DB25S,
with integrated shielded cable clamp
assembly (Amp type 826 985-1C) and
fastening screws (Amp type 164 868-1)
9
15
6