Example 1:
Enter or change values for standard configuration in single range
mode in the unit set under 1.7.x.
Select menu item ADC CON
) Confirm menu item ADC CON
(if necessary k) to select the menu item STAND
Standard configuration
) Confirm menu item STAND.
Range selection
) Confirm menu item RANGES
(if necessary press k repeatedly) Select menu item SINGLE
Single range mode
( Confirm menu item SINGLE
Weights
) Confirm menu item WEIGHTS
Scale interval
) Confirm menu item D
( ) k p Enter a value (e.g. 0.002 kg)
(if necessary press ) repeatedly) until display D appears
k Select menu item MAX.
Maximum capacity
) Confirm menu item MAX.
( ) k p Enter a value (e.g. 30 kg)
(if necessary press ) repeatedly) until display MAX appears
( Menu item UNITS is displayed
(if necessary press the ) key) to select available
weighing units (UNITS)
k Menu item SAVE is displayed
) k ) Save the entered value (YES)
or do not save (NO)
max.
Stand.
Example 2:
Enter or change values for standard configuration in a multi-
interval scale in the unit set under 1.7.x.
(the same applies for multiple range mode).
Select menu item ADC CON
) Confirm menu item ADC CON
(if necessary press and select the menu item STAND.
)k p)
Standard configuration
) Confirm menu item STAND.
Range selection
) Confirm menu item RANGES
(if necessary press k repeatedly) Select menu item MULT. INT
Multi-interval scale
( Confirm menu item MULT. INT
Weights
) Confirm menu item WEIGHTS
Scale interval (e.g. 0.002 kg)
) Confirm menu item D
( ) k p Enter a value (e.g. 0.002 kg)
(if necessary press ) repeatedly)
until display D appears
k Select menu item RANGE 1
Enter values for the following in
the same way:
Range limit 1 (e.g. 6 kg)
Range limit 2 (e.g. 15 kg)
Maximum capacity (e.g. 30 kg)
Continue as shown in example 1
after entering the maximum
capacity
max.
Stand.
To Next Page
Loading...
Need help?
General
