Sartorius PR 5210/00 - Status; Analog Part Weight Status

Setup and Configuration PR 5210 Operating Manual
32 Sartorius
4.11 Status
In this menu the actual status of the weight and the digital inputs and outputs is displayed. The scale
could be tared, set to zero and switched to the test mode.
Weight actual weight
Outputs Status of the digital outputs
Inputs Status of the digital inputs
Zero offset Zero offset from calibrated zero point. By using the set zero function the
new zero point differs from the calibrated zero point.
Switch test mode on- and off.
Tare and reset tare
Set zero
4.11.1 Analog part weight status
Display Error 3 Error 7 negative
0
È
positive
FSD
(SKE)
È
Error 2 Error 3
ű0,25dÆ ÅoverloadÆ
Bit E3 E7 Below0 CZERO aboveFSD E2 E3
InZSR ÅDeadLd±InsideZSRÆ
ADUERR ADUERR ADUERR
W&M off
- - - DIMM
W&M on
- DIMM - DIMM