79
EN
Operating Instructions SATA lter 500
Operating Instructions SATA lter 500
4. Check that the bayonet of the lter housings has engaged (Caution!
Filter housings are only correctly tted after an audible “click”!)
5. Slowly open upstream shut-o tap (not included in delivery)
6. Turn regulating cap [1-8] clockwise until required pressure is dis-
played in the pressure gauge [1-6].
7. Check pressure when operating the spray gun (trigger fully pulled)
and re-adjust if necessary.
9. Function
9.1. Filter stage [A]:
The rst ltering stage separates particles > 5 µ as well as condensed wa-
ter and oil. A sinter lter (Art. No. 22160) is integrated in the lter.
Notice!
Sintered filter:
• Fineness 5µm
If a certain condensate level is exceeded, the automatic condensate drain
valve [1-10] opens under pressure. Apart from a small residual quantity,
the condensate is drained through the condensate drain hose [1-14] into
the container (not included in delivery).
9.2. Filter stage [B]:
The ne lter cartridge (Art. No. 1097999) in the second lter stage
separates smallest particles together with aerosols.
Notice!
Fine filter cartridge:
• Special micro bre eece
• Fineness 0.01 µm, separation degree 99.998 % related to a particle
size > 0.01 µm
9.3. Filter stage [C]:
The activated charcoal cartridge (Art. No. 1098004) in the third lter
stage absorbs aerosols. Filter stages [A] and [B] must always be tted
upstream from an activated charcoal lter.
To Next Page
Loading...