Satec EM132 Quick Start Guide

EM132-133 QUICK START GUIDE
BG0504 REV.A2
Mechanical Installation
Figure 2: Mounting the EM133 on DIN Rail or on flat surface
IMPORTANT!
Only qualified personnel can perform setup.
All incoming power sources must be turned off during installation. During operation of the Powermeter,
hazardous voltages are present on the input terminals. Failure to observe precautions can result in
serious or even fatal injury, or damage to equipment.
Please refer to the installation and operation manual for further information.

Satec EM132 Specifications

General

Brand	Satec
Model	EM132
Category	Measuring Instruments
Language	English