Need help?Do you have a question about the Satec PM175 and is the answer not in the manual?
General| Communication Ports | RS-485, Ethernet |
|---|---|
| Display | LCD with backlight |
| Frequency Range | 45-65 Hz |
| Installation | Panel mount |
| Current Input | 1A or 5A via CT; Burden: <0.2VA per phase |
| Communication Protocols | Modbus RTU, Modbus TCP |
| Accuracy | Class 0.2S |
| Power Supply | 85-265V AC/DC |
Details physical installation of the meter and remote display.
Covers wiring and connection of power and measurement inputs.
Explains connections for digital inputs, relay outputs, and analog signals.
Describes setup for serial, modem, and Ethernet communication ports.
Procedures for mounting the meter into a panel cutout.
Instructions for mounting the meter on a 35mm DIN rail.
Guidelines for installing the detachable display module.
Covers wiring diagrams and terminal connections.
Details connections for digital inputs, relay outputs, and analog signals.
Explains setup for COM1 and COM2 communication ports.
Overview of the meter's display, LEDs, and navigation buttons.
Explains how measurement data is shown and navigated.
Details how to view power quality and harmonic measurement data.
Guide to navigating the meter's menu system for setup.
Covers basic device settings, options, and port configurations.
Describes setting up site databases for meter configuration.
Explains how to configure communication settings for the meter.
Allows preparation of setup data for the meter offline.
Details configuration of basic meter parameters via PAS software.
Specifications for the meter's power input options.
Details for voltage and current input specifications.
Technical details of available communication interfaces.
Accuracy and range for various electrical measurements.
Defines conditions that can trigger setpoint actions.
Lists actions performed when a setpoint is activated.
Lists available event flags for status monitoring.
Details parameters related to pulse counting inputs.
Parameters related to current demand measurements.
Parameters for maximum harmonic demand values.
Defines parameters for analog inputs.
Lists parameters related to Time-of-Use tariffs.
Details parameters recorded for EN50160 compliance.
Details parameters for harmonic survey data.
Defines the maximum voltage scale.
Defines the maximum current scale.
Defines the maximum power scale.
To Next Page
