Need help?Do you have a question about the Satec PM172E and is the answer not in the manual?
General| Brand | Satec |
|---|---|
| Model | PM172E |
| Category | Measuring Instruments |
| Language | English |
Details on how to physically install the powermeter, including panel and DIN rail mounting.
General guidance and typical installation diagrams for electrical connections.
Overview of the meter's display, indicators, and control buttons.
Explains how to view and interpret the measured data displayed on the meter.
Instructions on navigating the meter's menus and operating its settings.
Guides on configuring fundamental device settings for meter operation.
How to create and manage site databases for meter configuration and data storage.
Configuring communication settings for the PM172 meter through PAS software.
Step-by-step guide for establishing serial port communication with the meter.
Preparing and configuring meter setup data offline using PAS software.
Process of transferring meter configurations from PAS to the device.
Retrieving meter configurations from the device and saving them in PAS.
How to configure communication ports in the meter using the PAS application.
Configuring network parameters like IP address and TCP service port for Ethernet communication.
Providing basic electrical network information and configuring essential meter parameters.
Enabling/disabling optional calculations and configuring user-selectable device settings.
Configuration of optional analog inputs, including type, scales, and decimal places.
Configuration of optional analog outputs, including type, scales, and parameters.
Setup for programmable setpoints, logical expressions, and actions.
Configuring summary and Time-of-Use (TOU) energy and demand registers.
Setting up daily tariff change points and schedules for energy usage.
Configuring season tariff schedules using the TOU calendar for annual tariff planning.
Partitioning the onboard memory for data, event, and waveform logging files.
Setting up the Event Log file, including file type and number of records.
Programming data log files to record specific parameters and their configurations.
Setting up waveform log files to capture and record voltage and current waveforms.
Downloading and installing new firmware to the meter through PAS.
To Next Page
