To Next PageTo Next Page
Need help?Do you have a question about the Satec PM130 series and is the answer not in the manual?
General| Frequency Measurement Range | 45-65 Hz |
|---|---|
| Power Measurement | Active, Reactive, Apparent Power per phase and total |
| Communication Ports | RS-485, Ethernet, USB |
| Protocols Supported | Modbus RTU, Modbus TCP, DNP3 |
| Display | LCD |
| Mounting | DIN rail or panel mount |
| Digital Inputs/Outputs | 4 digital inputs, 2 relay outputs |
| Humidity | 5-95% non-condensing |
Details on mounting the PM130 meter into a switchboard panel, including cutout types.
Provides the physical dimensions and measurements of the PM130 meter.
Crucial safety warnings regarding incoming power and hazardous voltages during installation.
Illustrates common wiring modes for the PM130, such as 4LL3 and 4L-n3*.
Explains the display panel, load bar graph, LEDs, and measurement parameters.
Step-by-step guide to configure the CT primary current value.
Guide to navigate through menus for basic and communication setup.
How to navigate through measurement parameters using arrow keys and dedicated buttons.
Instructions on how to scroll through different display pages.
Guides on how to select common, min/max, and energy measurements.
Details on wiring modes, PT ratio, CT primary current, and demand periods.
Explains reset functions and nominal power utility frequency settings.
Configuration options for communication protocols, interface, address, baud rate, and data format.
Ratings for voltage and current inputs, including isolation and overload withstand.
Specifications for communication ports, relay outputs, and power supply options.
