EasyManuals Logo

Satec PM172E User Manual

Default Icon
135 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #102 background imageLoading...
Page #102 background image
Chapter 4 PAS Application Software Administration
102 Series PM172 Powermeters
To reset the desired accumulation registers or to clear a file:
1. Click on the corresponding button, and then confirm your command.
2. If a target has more than one component, you are allowed to select
components to reset.
3. Check the corresponding boxes, and then click OK.
Administration
Changing a Password
PAS allows you to remotely change the password, and enable or disable the
password security check in your meter. To change the password, check the
On-line button, select Administration from the Monitor menu, and then select
Change Password.
To change the password:
1. Type in a new 4-digit password
2. Repeat the password in the Confirm box
3. Check the “Enable network protection” to enable password checking
4. Click Send.
Upgrading Device Firmware
Your meter has upgradeable firmware. If you need to upgrade your device,
download a new firmware file to the meter through PAS.
Firmware is downloaded through any communication port except the
Profibus port. The meter may be connected to your PC through a serial
interface, a dial-up modem or the Internet.

Table of Contents

Other manuals for Satec PM172E

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Satec PM172E and is the answer not in the manual?

Satec PM172E Specifications

General IconGeneral
BrandSatec
ModelPM172E
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals