Satec PM175 User Manual

Chapter 4 PAS Application Software
General Meter Setup
64
Series PM175 Powermeters
Basic Meter Setup
Before operating your meter, provide the device with basic
information about your electrical network.
To enter the Setup dialog, select the device site from the list
box on the PAS toolbar, and then select General Setup from
the Meter Setup menu.
The following table lists available device configuration options.
Parameter
Options
Default
Description
Basic Configuration
Wiring mode
See Table below
4LN3
The wiring connection of the device
PT ratio
1
1.0-6500.0
1.0
The phase potential transformer’s
primary to secondary ratio
PT Ratio multiplier
×1, ×10
×1
PT Ratio multiplication factor. Used in
extra high voltage networks to
accommodate the PT ratio for 500 kV
and higher networks.
CT primary current
1-20,000 A
5 A
The primary rating of the phase
current transformer
Nominal voltage
10-690 V
120 V
The nominal secondary line-to-neutral
(in 4LN3, 3LN3 and 3BLN3 wiring
modes) or line-to-line (in 4LL3, 3LL3,
3BLL3, 3OP2, 3OP3 and 3DIR modes)
voltage. Used as a reference voltage
for the EN50160 evaluation.
Maximum demand
load current
0-20,000 A
0
The maximum demand load current
(0 = CT primary)
Nominal frequency
50,60 Hz
60 Hz
The nominal line frequency

Satec PM175 Specifications

General

Brand	Satec
Model	PM175
Category	Measuring Instruments
Language	English