Satel CA-6 - Sound signaling; Codes and users

2 CA-6 SATEL
9 - change the keypad backlight mode [only in CA-6 KLED-S] – the number of short beeps
indicates which backlight mode is enabled (1 – no backlight; 2 – automatic backlight; 3 –
permanent backlight);
0 - trigger the auxiliary alarm;
- trigger the fire alarm;
# - trigger the panic alarm.
1.3 Sound signaling
Beeps generated during operation
1 short beep – pressing any number key.
3 short beeps – to signal:
− arming;
− disarming and/or alarm clearing;
− deactivating the 13. BI SWITCH type output by means of user functions.
4 short beeps and 1 long beep – to signal:
− entering the service function menu;
− activating the 12. MONO SWITCH or 13. BI SWITCH type output by means of user
functions;
− finishing the function and exiting the user menu, after confirming the entered data.
2 long beeps – an unknown code, unavailable function, or exiting the function without
confirmation of the data entered (after using key).
3 long beeps – refusal to arm (some zones are violated or battery failure).
Events signaled by sounds
1 short beep every 3 seconds – to signal:
− service mode;
− entry delay countdown.
2 short beeps every 3 seconds – trouble (the sound signaling of trouble will stop after
viewing the current troubles).
5 short beeps – zone violation (CHIME).
1 long beep every second – fire alarm.
1 long beep every 3 seconds – exit delay countdown.
5 long beeps – zone violation:
− the 4. DAY/NIGHT type, when the partition is disarmed;
− the counter type (triggers alarm after a preset number of violations), when the partition
is armed.
Continuous beep – alarm.
Notes:
• Only installer selected events are signaled.
• Alarms will be signaled as long as programmed by the installer.
2. Codes and users
To perform many of the CA-6 control panel functions you must enter a code. By default, the
following codes are preprogrammed in the control panel:
master (administrator) code for partition 1: 1234
service code: 12345