Satel PK-01 User Manual

SATEL PK-01 5
[7#] Program relay operation time
[8#] Configure relay operation time reducing function:
[0#] disabled
[1#] when door open
[2#] when door closed
[9#] Configure backlighting:
[0#] off
[1#] automatic
[2#] permanent
When navigating through the service mode, keep the following principles in mind:
1. After selecting a function from the main menu (from 1 to 9), the green and red LEDs will
be steadily lit.
2. After saving each change, the module will generate 4 four short beeps and 1 long beep.
The entry of erroneous data is indicated with 2 long beeps. In both cases, after generating
the signal, the device returns to the main menu.
3. To exit the function, without making or confirming any change, press the key.
Exiting the service mode
Press the key and confirm with the key. The module will generate 4 short beeps and 1
long beep.
Adding / editing the user code
Notes:
 Adding a new code is equivalent to adding a user.
 You can enter up to 49 user codes.
 You cannot delete the administrator.
 During the process of adding codes, it is recommended that you additionally make a list of
users and numbers assigned to them.
1. Press the key and confirm with the key. The module will generate 2 short beeps.
2. Enter the number of user to whom a code is to be added / whose code is to be changed.
Note: If the yellow LED lights up after entering the user number, it means that the code of a
user with this number is already saved in the module.
3. Confirm with the key. The module will generate 2 short beeps.
4. Enter the code.
Note: If the entered code has already been assigned to another user, the module will
generate 2 long beeps. In such a case the whole procedure of code adding should be
repeated from the beginning.
5. Confirm with the key. The module will generate 4 short beeps and 1 long beep.
Deleting the user code
1. Press the key and confirm with the key. The module will generate 2 short beeps.
2. Enter the number of the user whose code is to be removed.

Satel PK-01 Specifications

Power

supply voltage	12 V DC ±15%
standby current consumption	105 mA
maximum current consumption	125 mA

Operating Environment

maximum humidity	93±3%
operating temperature range	-25 to +55 °C
environmental class according to EN50130-5	III

Output Ratings

bell output rating	30 mA
alarm output rating	30 mA
relay contacts rating (resistive load)	2 A / 24 V DC

Frequency

reader working frequency	125 kHz

Weight and Dimensions

weight	297 g
enclosure dimensions	47 x 158 x 24 mm