Satelec Servotome - User Manual

Questions and Answers

D
Daniel StewartAug 9, 2025
What to do if Satelec Servotome is not incising at all?
- B
  Brianna BooneAug 9, 2025
  If the electrode of your Satelec dental equipment is not incising, consider the following: * Ensure the capacitive coupler is correctly positioned with the 'Patient Side' against the patient's lightly-clothed skin, like the scapula. * If the electrode is soiled, set the unit to 'O' and clean it. * Reduce your operating speed if you're moving the electrode too fast. * Check if you're using a suitable electrode for the procedure. * The electrode might be worn and needs replacement.
A
alvarezronaldAug 14, 2025
What to do if my Satelec Servotome isn't working and the green light is off?
- R
  rachael68Aug 14, 2025
  If your Satelec dental equipment isn't working and the green indicator lamp is off, check these possible causes: * Ensure the ON/OFF switch is set to 'I'. * Verify the mains lead is properly connected. * Check that there is electric current supply. * Replace the external fuses if they are not working. Note: there is a third internal fuse that is inaccessible; contact your dealer if this is the issue.
B
Brenda MoranAug 19, 2025
Why does the electrode stick to the tissue with Satelec Servotome Dental equipment?
- J
  Joseph WilliamsAug 20, 2025
  The electrode of your Satelec dental equipment might stick to the tissue because: * The power is set too low; increase it until you reach the incision threshold, without exceeding it. * You might be using an inappropriate electrode for the procedure; select the correct one.
M
Matthew CunninghamAug 25, 2025
What to do if my Satelec dental equipment indicator lamps are on, buzzer works, but there's no high-frequency current?
- A
  Abigail RodgersAug 26, 2025
  If the indicator lamps are on and the buzzer is working, but there is no high-frequency current in your Satelec dental equipment, check the following: * Ensure the electrode-holder cord is properly connected by pushing the unit-side and electrode-holder-side connectors in all the way. * Verify that the capacitive coupler is fully connected.
J
Julie HornAug 29, 2025
Why does my Satelec dental equipment electrode incise but there are sparks?
- E
  esextonAug 29, 2025
  If the electrode of your Satelec dental equipment incises but produces sparks, it's likely that the incision power is set too high. Reduce the incision power down to the necessary threshold.
S
scottreeseSep 3, 2025
What to do if the green light is on but the orange light and buzzer aren't working on my Satelec Servotome Dental equipment?
- K
  kellypaulSep 3, 2025
  If the green indicator lamp is lit, but the orange indicator lamp and buzzer are not working on your Satelec dental equipment, consider the following: * Check the footswitch lead and ensure it is firmly plugged in. * The footswitch may be faulty and needs replacement. * The device might be under thermal protection, wait for it to cool down.