II - INSTALLATION
2. 1 RECOMMENDATIONS
For your safety, connection to the electrical circuit
should be carried out by an approved dental
installation engineer.
Important: before using the device for the first time,
clean, decontaminate and sterilize the accessories
(in particular the electrode-holder and the
electrodes). See Section 5 - Maintenance.
2. 2 SETTING UP THE EQUIPMENT
- Place the device where it is to be used, on a level
surface or on one that has a slope of less than 10º.
- Plug in the electrode-carrier cord (8).
- Connect the footswitch (9) to the footswitch
connector (15).
- Connect the capacitive coupler (5) to its socket
(14).
- Connect the mains plug into the mains socket (18).
It is essential for the mains socket to be earthed.
III - RECOMMENDATIONS FOR
USE
3. 1 GENERAL RECOMMENDATIONS
Before the SERVOTOME
®
is used for the first time, it is
essential to carry out tests on anatomical parts
(pieces of meat - ideally, a piece of beef heart,
chicken breast, etc.) to determine how they react to
incision and to help adopt the right clinical procedure
(electrode movement speed). Repeat these exercises
as many times as necessary.
3. 2 THE DEVICE
Make sure the device is properly plugged in and
insulated. Use of the mains socket with its earthed
connection is mandatory.
The user should check the accessories and leads
regularly so as to locate any insulation fault and
replace them if and when necessary.
Do not use the device if it appears to be defective in
any way.
In the event of a malfunction, you are advised to
contact your SERVOTOME
®
supplier rather than an
official repairs technician.
3. 3 ELECTRODES AND ELECTRODE-HOLDERS
It is essential to replace used or damaged SERVOTOME
®
accessories with the appropriate new SATELEC
accessories.
To avoid damaging or burning out the SERVOTOME
®
, it
should not be used with any accessories other than
those supplied by SATELEC.
Prior to each use, the electrodes and electrode-
holder must be cleaned, decontaminated and
sterilized.
8
To Next Page
Loading...
