Operator's Manual: Models Saturn™ 140 & Saturn™ 230
3-2
Complete assembly of the furnace according to the following list of activities as illustrated above:
(1) Installing the Observation Port
(2) Installing the Louvers
(3) Installing the Combustion Sleeve
(4) Installing the Burner
(5) Installing the Connector Block, Oil Line Tubing, and Air Line Tubing
NOTE: Corresponding procedures provided in order in this section.
Figure 3A - Overview of Furnace Assembly
2
3
COMBUSTION SLEEVE
INSTALLED IN CHAMBER
ON 2" X 2" BLOCKS
LOUVERS
4
BURNER
MOUNTING
BRACKET
4
"ALL THREAD" RODS
1
OBSERVATION
PORT
5
CONNECTOR
BLOCK
I89086-A
To Next Page
Loading...