Saturn 125 - Appendix A; Detailed Furnace Specifications

Operator's Manual: Models Saturn™ 140 & Saturn™ 230
A-1
APPENDIX A
Detailed Furnace Specifications
* Nominal values; actual values may vary depending on installation.
Furnace Model Saturn
TM
140 Saturn
TM
230
BTUH Input 140,000*
@ 1.0 GPH
230,000*
@ 1.6 GPH
Listed Fuels: #2 Fuel Oil
#4 and #5 Fuel Oils (U.S.)
Used Crankcase Oil
Used ATF (U.S.)
Used Hydraulic Oil
#2 Fuel Oil
#4 and #5 Fuel Oils (U.S.)
Used Crankcase Oil
Used ATF (U.S.)
Used Hydraulic Oil
Cabinet Dimensions
(LxWxH) inches
47.25 x 32 x 20 54.5 x 35 x 23
Furnace Dimensions
w/ fan, Burner, and Louvers
(LxWxH) inches
61.25 x 32 x 31.5 68.5 x 35 x 34.5
Approximate Weight
(complete furnace system – uncrated)
220 lbs. 280 lbs.
Mounting (NFPA-31)
1) Ceiling hung
2) Raised platform
3) Bench Tank Kit
1) Ceiling hung
2) Raised platform
3) Bench Tank Kit
Electrical Requirements
(VAC @ 60 Hz)
115 115
Circuit Breaker 20 amps 20 amps
Wall Thermostat 24 volt 24 volt
Oil Pump Suntec
A2RA-7720
Suntec
A2RA-7720
Oil Pump Motor Bison Gear Motor
1/20 HP
Bison Gear Motor
1/20 HP
Pump Motor Rotation CCW shaft end CCW shaft end
Canister Filter Lenz
DH 750-100
Lenz
DH 750-100
Stack Size 6” 6”
Fan Motor HP
1
/
4
HP
1
/
3
HP
Blower/Fan Switch F180 F180
Hi-Temp Limit Switch L200 L200
Auxiliary Hi-Temp Switch L290 (Auto-Reset) L290 (Auto-Reset)
Approx. Air Compressor
Requirements
2.5 CFM
@ 30 PSI
2.5 CFM
@ 30 PSI