Operator's Manual: Models Saturn™ 140 & Saturn™ 230
3-4
Installing the Air Outlet Louvers (continued)
Figure 3C - Installing the Hot Air Discharge Louvers
ATTENTION: If the bottom clearance is less than 60 inches use a hot air diffuser as described under Floor
Mounting in Section 4.
1. Refer to Figures 3C. Determine the desired air flow discharge direction. Note that each furnace is
supplied with four (4) louvers.
2. Hold each louver against the base with the bend pointing down. Install the louvers in the desired
direction(s) with the self-tapping screws provided. Holes are pre-drilled in the furnace base to
accommodate installation of the louvers.
3. Rotate the louvers to help direct the hot air away from the furnace.
CAUTION: The Saturn™ 140 and Saturn™ 230 are Unit Heater furnaces ONLY. DO NOT install
ductwork on these furnaces.
To Next Page
Loading...